Intermec SF61B 1D Guía de usuario descargar pdf (Pagina 78)

Chapter 4 — Troubleshoot and Maintain the SF61B

66 SF61 Cordless Scanner User’s Guide

will do so with an HID connection or a scanner-initiated Incoming

SPP connection for example).

Force a Software Reset

A software reset of your scanner will reset its parameter settings to

their initial values so you will have to reconfigure any custom settings

you have programmed in your scanner (see Chapter 3, Configure the

SF61B Cordless Scanner).

To force a software reset (Reset factory defaults) of your SF61B

1 Turn the scanner on by pressing the trigger one time, then release.

2 Press and hold the scan button for 30 seconds until the red LED

comes on.

The scanner will beep after 20 seconds (hardware reset) however,

keep the trigger pressed until the red LED comes on (10 more

seconds after the hardware reset).

3 Press the scan button very rapidly five times in succession while

the red LED is on (you need to be quick as the red LED only stays

on for 2 seconds).

The green LED comes on, the scanner beeps a reset confirmation

(six-beep melody) and powers off and powers on (two beeps and

vibrate alert by default).

If you had a Bluetooth connection before the software reset, the

SF61B will disconnect from the host device.

Note: You may not be able to tell if the scanner is on, for example if

the LEDs have been disabled and do not light up when you pull the

trigger.

Note: Depending on your host configuration (device, Bluetooth

version), after a software reset of your scanner (Reset factory defaults)

you may have to re-pair your product with your host device /

application (see the appropriate section in Chapter 2, Connect the

SF61B).

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 103 104

Sin comentarios

Intermec SF61B 1D Guía de usuario Pagina 78