Intermec CN2G Manual de usuario descargar pdf (Pagina 50)

Chapter 2 — Configuring the CN2G

38 CN2G Handheld Computer User’s Manual

Note: You must have the date on the CN2G set correctly

when you enable Validate Server Certificate.

If you choose TLS:

a For Validate Server Certificate, choose Enabled and tap

Save.

b You must enter a User Name and Subject Name. You can

also enter a Server Common Name if you want to increase

your level of security.

8 Exit Intermec Settings.

To enable WPA-PSK security on your CN2G with Funk security

1 Make sure you have configured the communications and

radio parameters on your CN2G.

2 Make sure you have selected Funk as your security choice.

3 Open Intermec Settings.

4 Choose Communications > 802.11 Radio > Security

Settings > Funk Security > Profile.

5 For Association, choose WPA and tap Save.

6 For Authentication, choose None and tap Save.

7 For Pre-Shared Key, enter the pre-shared key or the

passphrase.

The pre-shared key must be a value of 32 hex pairs preceded

by 0x for a total of 66 characters. The value must match the

key value on the access point. The passphrase must be from 8

to 63 characters. After you enter a passphrase, the CN2G

internally converts it to a pre-shared key.

This value must match the passphrase on the authenticator.

8 Exit Intermec Settings.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 101 102

Sin comentarios

Intermec CN2G Manual de usuario Pagina 50