Intermec PF8D Manual de usuario descargar pdf (Pagina 71)

Chapter 3 — Troubleshooting and Maintaining the Printer

PF8d and PF8t Desktop Printer User’s Guide 59

If you are using Gap sensing or Continuous stock, this sensor MUST

be in the default, far-right position, or “Out of Paper”, “Media not

Loaded”, or other media fault errors may continually occur.

To locate and adjust the black mark/label stop sensor

1 Open the top of the printer.

2 Lift the printhead.

The black mark sensor is near the front of the printer, behind the

roller, in a groove that runs from the left side to the middle of the

printer. The sensor optics are visible as a small slit on the left, and

there is a ridged finger-notch to the right.

3 If the sensor is not all the way to the right, put your fingertip in

the ridged finger-notch and slide the sensor all the way to the

right. Do not touch the sensor itself, because natural finger oils

may dirty the optics.

4 Lower the printhead, close the printer, and try printing again.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 91 92

Sin comentarios

Intermec PF8D Manual de usuario Pagina 71