
Chapter 3 — Configuring the CK32 I-Safe
50 CK32 I-Safe Handheld Computer User’s Manual
Configuring the Network Parameters for a TCP/IP Network
In a TCP/IP network, the CK32 I-Safe communicates with a
host computer directly using TCP/IP. The access point acts as a
bridge to allow communications between the wired network and
the wireless network.
To use wireless communications in a TCP/IP network
1 Tap the iConnect icon ( ) in the lower right corner of the
Today screen.From the menu, select Enable > Wireless. This
disables the Ethernet connection.
2 You will be prompted to reboot the device for changes to take
affect. Press and hold the Power button for 10 seconds to
initiate the reboot. Do not use the Reset button. See
“Preferred Reset method” on page 114 for more information.
3 Go to Start > Settings > the System tab > Intermec Settings
> Communications > 802.11 Radio.
4 Configure these network parameters on each CK32 I-Safe in
the network:
• Network name (SSID)
• IP settings (if not using DHCP)
5 Make sure that the CK32 I-Safe is talking to the network and
that the network can see the CK32 I-Safe.
Comentarios a estos manuales