Intermec CK32IS Manual de usuario descargar pdf (Pagina 67)

Chapter 3 — Configuring the CK32 I-Safe

CK32 I-Safe Handheld Computer User’s Manual 51

6 Configure security. For help, see See “Using ISpyWiFi” on

page 52.

You can configure the network parameters on the CK32 I-Safe to

using Intermec Settings or ISpyWiFi. For information on

Intermec Settings, see “Configuring the CK32 I-Safe Using

Intermec Settings” on page 40.

Configuring the Network Parameters for a UDP Plus Network

In a UDP Plus network, the CK32 I-Safe communicates with a

host computer through the Intermec Application Server. The

Intermec Application Server translates UDP Plus packets on the

wireless network into TCP/IP packets on the wired network and

vice versa. The access point acts as a bridge to allow

communications between the wired network and the wireless

network.

To use wireless communications in a UDP Plus network

1 Go to Start > Settings > the System tab > Intermec Settings

> Communications >UDP Plus.

2 Configure these network parameters on the CK32 I-Safe:

• UDP Plus Activate

• Controller IP address

• Controller Port

3 Make sure the CK32 I-Safe is talking to the network and that

the network can see the CK32 I-Safe.

4 Configure security. For help, see “Configuring Security on the

CK32 I-Safe” in the next section.

Checking the Status of Your Wireless Connection

After you configure your wireless settings, you can use iConnect

to check the status of your connection.

To check the status of your wireless connection

1 Tap the iConnect icon ( ) in the lower right corner of the

Today screen.

2 From the menu, select Status > Wireless. The Wireless Status

screen appears and checks the connection.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 148 149

Sin comentarios

Intermec CK32IS Manual de usuario Pagina 67