
Chapter 5 — Network Support
CN3 Mobile Computer User’s Manual 147
Insert necessary equipment, such as a network card, into the CN3, and
use a desired program to begin connecting.
Ending a Connection
Use any of these methods to end your connection:
• When connected via cable or cradle, detach your CN3.
• When connected via Infrared, move the CN3 away from the other
computer or device.
• When connected via a wireless network, switch off the connection.
iConnect
The default network adapter or radio is dependent on what radios are
installed in your CN3. With the iConnect menu, using the Enable feature,
you can specify “Wireless” or “No Networking” to load onto your CN3
when a cold-boot is performed.
If you had specified a network prior to when a warm-boot is performed on
the CN3, the iConnect application restores your network interfaces to what
they were before the warm-boot was performed.
See the Developer’s Support area of the Intermec web site for the latest
information on network adapters for your unit.
• When connected via modem or VPN, tap the Connectivity icon on the
top, then tap Disconnect.
Note: Contact your Intermec representative for information regarding the
FTP activation scheme.
Comentarios a estos manuales