Intermec CN2B Manual de usuario descargar pdf (Pagina 21)

Chapter 1 — Using the CN2B Computer

CN2B Mobile Computer User’s Manual 3

Battery

The CN2B Computer comes with an 7.95 Watt-hour, 3.7V, 2150mAh,

replaceable LiIon battery. To view the status of this battery, tap Start > Set-

tings > the System tab > the Power icon > the Power tab to view the cur-

rent status of both the main battery and the backup battery. Tap ok to exit.

If your computer shuts down because of low battery conditions, your com-

puter does not operate. This is done to ensure that data is protected.

Although the battery does protect the data against loss for several hours,

you should connect your computer to a power source when you first detect

a low battery condition.

Your computer contains an internal supercapacitor, a temporary power

storage device, that protects data for up to ten minutes. This is to give you

time to replace the main battery pack before that data is lost. Be sure to put

the computer in a suspend mode before doing so.

The lithium-ion battery pack that is used in this device may present a

fire or chemical burn hazard if it is mistreated. Do not disassemble it,

heat it above 100°C (212°F), or incinerate it.

Removing the main battery when the backup battery low or critically

low icon appears on the status bar may cause your CN2B Computer to

cold boot and you may lose data.

If you fail to replace the battery immediately, you may lose important

data or applications.

If you have at least one device in your CN2B Computer (radio, scanner, or

imager), the battery power fail level is set so that after the system shuts

down in a low battery condition, there is still sufficient charge to allow the

unit to remain configured, keep proper time, and maintain DRAM

(Dynamic Random Access Memory) for at least 23 to 32 hours at room

temperature if the main battery remains in the mobile computer.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 263 264

Sin comentarios

Intermec CN2B Manual de usuario Pagina 21