Intermec CN2B Manual de usuario descargar pdf (Pagina 233)

Appendix A — Configurable Settings

CN2B Mobile Computer User’s Manual 215

Using Reader Commands

After the CN2B Computer is connected to your network, you can send the

CN2B Computer a reader command from an application to perform a task,

such as changing the time and date. Some reader commands temporarily

override configuration settings and some change the configuration settings.

Change Configuration

The Change Configuration command must precede any configuration

command. If you enter a valid string, the CN2B Computer configuration is

modified and the computer emits a high beep. To send the Change Config-

uration command through the network, use the $+ [command] syntax

where command is the two-letter command syntax for the configuration

command followed by the value to be set for that command.

You can also make changes to several different commands by using the

$+ [command]...[command n] syntax. There are seven configuration

command settings that you can change in this way. See each command for

information on respective acceptable “data” values.

Command Syntax

Audio Volume BVdata

Automatic Shutoff EZdata

Backlight Timeout DFdata

Key Clicks KCdata

Virtual Wedge Grid AFdata

Virtual Wedge Postamble AEdata

Virtual Wedge Preamble ADdata

Example 1

To change the Beep Volume to Off, you can send this string to the CN2B

Computer through the network: $+BV0

where:

$+ Indicates Change Configuration.

BV Specifies the Audio Volume parameter.

0 Specifies a value of Off.

Example 2

To change the Beep Volume to Very Quiet and the Virtual Wedge Grid to

123:

$+BV1AF123:

$+ Indicates Change Configuration

BV1 Specifies Audio Volume, set to Very Quiet (1)

AF123 Specifies Virtual Wedge Grid, set to a value of 123.

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 263 264

Sin comentarios

Intermec CN2B Manual de usuario Pagina 233