Intermec PB22 Manual de usuario descargar pdf (Pagina 51)

Chapter 2 — Configuring the PB22 and PB32

PB22 and PB32 Mobile Label and Receipt Printer User’s Guide 39

where xxxxxxxxxx is a value between 8 and 64 characters.

3 Send the following command to activate the settings:

<STX><SI>ws,ACTIVE,1<ETX>

To configure the printer to use WPA or WPA2 Enterprise mode

1 Send the following commands to login as an admin and set the

SSID:

<STX><ESC>.x,su -p pass admin<ETX>

<STX><SI>ws,SSID,xxxxx<ETX>

where xxxxx can be from 0 to 32 alphanumeric characters.

2 Send one of the following commands to enable WPA-802.1x or

WPA2-802.1x authentication. You should also send the WPA_PSK

command that does not contain a value:

3 Send these commands to configure the EAP_TYPE:

where xxxx can be OFF, LEAP, PEAP, or TTLS.

where xxxx is the unique username and the unique password for

this protocol.

4 If you are using TTLS, you may need to send this command to set

the TTLS outer name:

where xxxx is the outer name.

5 If you are using certificates for validation, here are some

commands you may need to use.

• Send the following commands to set a certificate and enable

validation:

Note: The default password for logging in as an admin is “pass.” If

you have changed the password, you will need to use your

password instead of “pass.”

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 103 104

Sin comentarios

Intermec PB22 Manual de usuario Pagina 51