Intermec IF61 Manual de usuario descargar pdf (Pagina 49)

Chapter 2 — Configuring Network Settings

IF61 Fixed Reader User’s Manual 35

2 Make sure the Enable RADIUS check box is not checked. Clear

this check box if necessary and then click Activate Changes.

3 Configure the parameters. For help, see the next table.

4 Click Activate Changes to save your changes and immediately

make them active.

Disabling Access Via the Serial Port

When serial port access is disabled, you will not be able to configure

the IF61 as described in “Assigning an Initial IP Address” on

page 9. You must use a network application (such as a web browser,

SmartSystems Console, Device Configuration Web Service

application, or Avalanche Console) for all configuration.

To disable serial port access

1 From the menu, click Security > Passwords. The Passwords

screen appears.

Password Parameter Descriptions

Parameter Description

Username Enter the user name you need to use to log in to this IF61.

The user name can be from 1 to 32 characters long. You

must always specify a user name. Default is

intermec.

Password Enter the password you need to use to log in to this IF61.

This password gives you read and write access to the IF61

configuration. The password can be from 8 to 32

characters long. You must always specify a password.

Default is

intermec.

Read-only

Password

Enter the password you need to use to log in to this IF61.

This password gives the user read-only access to the IF61.

This user can view the configuration and execute

diagnostics but cannot perform any tasks that affect IF61

operation, such as changing configuration options or

downloading software. Default is

readonly.

The read-only password cannot be deleted. To disallow

read-only access, you need to enable RADIUS

authentication. For help, see “Configuring Security” on

page 29.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 151 152

Sin comentarios

Intermec IF61 Manual de usuario Pagina 49