Intermec IF61 Manual de usuario descargar pdf (Pagina 81)

Chapter 3 — Developing and Using RFID Applications

IF61 Fixed Reader User’s Manual 67

No Tag Report

Enables or disables a NOTAG message, which is sent when no tags are

found during execution of a Read, Write, or Lock command. Check

the check box to enable the message. This setting is equivalent to the

NOTAGRPT BRI attribute, and is enabled by default.

Report Timeout

Sets the timeout (in ms) for delays in tag reporting when the IF61 is in

continuous read mode. Range is 0 (default) to 65534.

Timeout Configuration Mode

Enables a timeout mode. Instead of specifying the number of antenna

or ID tries, you specify an antenna or ID timeout value. If the IF61

does not find any tags after an antenna or ID try, the reader waits this

long before starting the next antenna or ID try. If you enable timeout

mode, you need to set the ID Timeout and Antenna Timeout values.

This setting is equivalent to the TIMEOUTMODE BRI attribute, and

is disabled by default.

To enable Timeout Configuration mode

1 Check the check box and then click Activate Changes. The screen

refreshes. The Antenna Tries setting is replaced by Antenna

Timeout, and the ID Tries setting is replaced by ID Timeout.

2 Specify the value (in ms) for the antenna or ID timeout in the

entry fields and then click Activate Changes.

For more information on ID Timeout and Antenna Timeout, see

those topics later in this section.

Select Tries

(Not supported by EPCglobal Class 1 Gen 2 tags) Sets the number of

times a group select is attempted. A group select is the command that

starts the identity process. Valid range is 1 (default) to 254.

This setting is equivalent to the SELTRIES BRI attribute.

Unselect Tries

(Not supported by EPCglobal Class 1 Gen 2 tags) Sets the number of

times a group unselect is attempted. Valid range is 1 (default) to 254.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 151 152

Sin comentarios

Intermec IF61 Manual de usuario Pagina 81