Intermec CN2 Manual de usuario descargar pdf (Pagina 101)

Chapter 5 — Troubleshooting and Maintaining the CN2

CN2 Handheld Computer User’s Manual 89

Problems With Wireless Connectivity (continued)

Problem Solution

The no network connection icon (

)

appears on the status bar.

The no network connection icon appears in three

situations:

• The CN2 may not have an IP address. You must

configure an IP address for the CN2 or make

sure that DHCP assigned an address. Use

Intermec Settings and select the radio tab to

make sure an IP address has been assigned. For

help, see “Configuring the CN2 Locally With

Intermec Settings” on page 32.

• The CN2 may not be connected to the access

point. Try these possible solutions in order:

• Make sure the access point is turned on and

operating.

• Make sure you are not using the CN2 out of

range of an access point. Try moving closer to

an access point to re-establish

communications.

• Make sure the CN2 is configured correctly for

your network. The radio parameters on the

CN2 must match the values set for all access

points the CN2 may communicate with. For

help, see “Configuring 802.11b/g Radio

Communications” on page 39.

• If you have an 802.11b/g radio, the radio

initialization process may have failed. Try

resetting the CN2. For help, see “Booting the

CN2” on page 94.

• If you have tried these possible solutions and the

no network connection icon still appears, you

may have a defective radio card. For help, contact

your local Intermec service representative.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 133 134

Sin comentarios

Intermec CN2 Manual de usuario Pagina 101