Intermec CN2 Manual de usuario descargar pdf (Pagina 69)

Chapter 3 — Adding the CN2 to the Network

CN2 Handheld Computer User’s Manual 57

• a Cisco access point with an 802.11b/g radio.

Note: LEAP security is not supported if you chose Microsoft

Security software, as described in “Choosing Between Microsoft

Security and Funk Security Software” on page 45.

To enable LEAP security on your CN2

1 Make sure you have configured the communications and

radio parameters on your CN2.

2 Make sure you have selected Funk as your security choice, as

described in “Choosing Between Microsoft Security and Funk

Security Software” on page 45.

3 Open Intermec Settings.

4 Tap Communications > 802.11 Radio > Security Settings

> Funk Security > Profile.

5 For Authentication, select LEAP and then tap Save.

6 For Association, select Open or Network EAP and then tap

Save.

7 For Encryption, select WEP, and then tap Save.

8 Select User name, type your user name, and then tap Save.

9 Select Password prompt, choose Enter password now, and

then tap Save.

Note: You can use Prompt for password to troubleshoot

your connection to the network if you have problems.

10 Select User Password, type a user password, and then tap

Save.

11 Exit Intermec Settings.

Using Static WEP Security

The CN2 uses the Wired Equivalent Privacy (WEP) protocol to

add security to your wireless network based on the 802.11b

standard.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 133 134

Sin comentarios

Intermec CN2 Manual de usuario Pagina 69