Intermec CN2 Manual de usuario descargar pdf (Pagina 63)

Chapter 3 — Adding the CN2 to the Network

CN2 Handheld Computer User’s Manual 51

7 For Pre-Shared Key, enter the pre-shared key or the

passphrase.

The pre-shared key must be a value of 32 hex pairs preceded

by 0x for a total of 66 characters. The value must match the

key value on the access point. The passphrase must be from 8

to 63 characters. After you enter a passphrase, the CN2

internally converts it to a pre-shared key.

This value must match the passphrase on the authenticator.

8 Exit Intermec Settings.

Configuring WPA Security With Microsoft Security

Use these procedures to set WPA-802.1x and WPA-PSK

security on your CN2 with Microsoft security. These procedures

assume that you have selected Microsoft Security software as

your security choice, as described in “Choosing Between

Microsoft Security and Funk Security Software” on page 45.

To enable WPA-802.1x security on your CN2 with Microsoft security

1 Make sure you have configured the communications and

radio parameters on your CN2.

2 If you plan to use TLS for authentication, load a user and

root certificate on your CN2. For help, see “Loading

Certificates” on page 59.

3 Open Intermec Settings.

4 Tap Communications > 802.11 Radio > Security Settings

> Microsoft Security.

5 For Infrastructure Mode, choose Infrastructure.

6 For Network Authentication, choose WPA and tap the Save

icon in the upper right corner of the screen. Data Encryption

is set to TKIP by default.

7 For 802.1x Authentication, choose either TLS or PEAP.

If you choose TLS:

a Tap Properties and tap Run App. The Authentication

Settings box appears.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 133 134

Sin comentarios

Intermec CN2 Manual de usuario Pagina 63