Intermec CN2 Manual de usuario descargar pdf (Pagina 70)

Chapter 3 — Adding the CN2 to the Network

58 CN2 Handheld Computer User’s Manual

To use WEP security, you need:

• an access point with an 802.11b/g radio.

• a CN2 handheld computer with an 802.11b/g radio.

Configuring Static WEP Security With Funk Security

1 Make sure you have configured the communications and

radio parameters on your CN2.

2 Make sure you have chose Funk Security software as your

security choice, as described in “Choosing Between Microsoft

Security and Funk Security Software” on page 45.

3 Open Intermec Settings.

4 Tap Communications > 802.11 Radio > Security Settings

> Funk Security > Profile.

5 For Association, choose Open, and then tap Save.

6 For Encryption, choose WEP and then tap Save.

7 For Authentication, choose None and then tap Save.

8 Select WEP Key and then define a value for each WEP key.

You can define up to four WEP keys.

Enter an ASCII key or a hex key that is either 5 bytes or 13

bytes long depending on the type of WEP encryption you are

using. Set a 5-byte value for 64-bit WEP or a 13-byte value

for 128-bit WEP. Hex values must be preceded by 0x and

contain 5 or 13 hex pairs.

9 Select Network Key Index, choose the WEP key you want to

use for transmitting data.

10 Exit Intermec Settings.

Configuring Static WEP Security With Microsoft Security

1 Make sure you have configured the communications and

radio parameters on your CN2.

2 Make sure you have selected Microsoft as your security

choice, as described in “Choosing Between Microsoft Security

and Funk Security Software” on page 45.

3 Open Intermec Settings.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 133 134

Sin comentarios

Intermec CN2 Manual de usuario Pagina 70