Intermec PM43c Manual de usuario descargar pdf (Pagina 46)

Chapter 2 — Set Up the Printer

34 PM43 and PM43c Mid-Range Printer User Manual

About Test Labels

Print a test label after you have loaded media and ribbon to verify that

you have installed everything correctly and also to get some important

information about your printer. The way you print a test label is

slightly different between the full touch and the icon printer. Please

use the procedure for your printer.

Print a Test Label with the Icon Printer

When you turn on the icon printer, all of the LEDs on the display light

up including the Ready-to-Work indicator. One by one, the LEDs turn

off as the printer starts up. The first LED to turn off is the Ready-to-

Work indicator. The LEDs then turn off following a sequence from the

top left LED to the bottom right LED.

1 Connect the printer to power and turn on the printer.

2 The printer goes through its startup sequence and all of the LEDs

light up. When the last two LEDs are lit (Printhead Hot and

Maintenance), press and hold the Print button until the test label

starts to print.

3 Release the Print button.

The series of three test labels prints out.

Print a Test Label with the Full Touch Printer

The first time you turn on the full touch printer or reset to factory

defaults, the printer runs a startup wizard to let you enter basic setup

information. After the startup wizard finishes, the printer enters Ready

mode where you can choose to access the Main Menu and print a test

label.

1 Connect the printer to power and turn on the printer.

2 After the startup sequence finishes, the startup wizard begins. After

you enter all of the information on the wizard screens, click No

when prompted to run other wizards.

3 From the Ready screen, tap the Main Menu button on the status

bar.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 149 150

Sin comentarios

Intermec PM43c Manual de usuario Pagina 46