Intermec PM43c Manual de usuario descargar pdf (Pagina 89)

Chapter 5 — Troubleshoot the Printer

PM43 and PM43c Mid-Range Printer User Manual 77

Printhead Too Hot The printhead is overheated and needs to cool down.

Wait for printing to resume automatically.

Printhead Not

Detected

The printer is not detecting the printhead. Check to

make sure the printhead is installed and that the

printhead cable is firmly connected to the printhead.

Faulty Dot The printhead has reached the number of faulty dots

set in the Faulty Dots setting in Maintenance Alerts.

You may need to replace the printhead.

Replace Printhead The printer has reached a limit set in the Replace

Printhead setting in Maintenance Alerts for the

amount of media to print before replacing the

printhead. Replace the printhead.

Clean Printhead The printer has reached a limit set in the Clean

Printhead setting in Maintenance Alerts for the

amount of media to print before cleaning the

printhead. Clean the printhead.

No RFID Tag Found The printer can not find an RFID tag.

RFID Not Installed You are attempting to write to a tag, but the printer

does not support RFID. You must install the RFID

module in the printer to be able to write to RFID

tags.

Upgrading Firmware The printer is going to start upgrading the firmware.

Do not try to send anything to the printer.

Printer is Rebooting The printer is going to restart. Wait until the printer

is ready before attempting to communicate with it.

Started The printer is in the process of starting up.

Motor Too Hot The printer motor has reached its maximum

operating temperature limit. Let the motor cool

down before you resume printing.

Error Alert Solution

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 149 150

Sin comentarios

Intermec PM43c Manual de usuario Pagina 89