Intermec PM43c Manual de usuario descargar pdf (Pagina 51)

Chapter 3 — Connect the Printer

PM43 and PM43c Mid-Range Printer User Manual 39

Connect the Printer Using a USB Cable

Intermec recommends that you only connect one printer to your PC,

either directly or through a hub. To connect the printer to a PC

through the USB device port, you need:

• a USB Type A to USB Type A cable.

• Intermec InterDriver ® software. To make sure you have the latest

version of InterDriver, go to the download website at

http://www.intermec.com/products/pswinterdriver

/index.aspx.

To connect the printer to your PC using a USB cable:

1 Download and install the InterDriver software on your PC.

2 Connect one end of the USB cable to the back of the printer and

connect the other end to your PC.

You do not need to set up any parameters for USB communications.

Connect the Printer Using an IEEE 1284 Cable

If you want to use a parallel port on the printer, you can choose to have

the IEEE 1284 parallel port installed either at the factory or by an

authorized Intermec service technician. You can use the parallel port

with InterDriver. The parallel port supports Universal Plug and Play

(UPnP), compatibility, nibble, byte, ECP, and additional status

reporting through IEEE 1284 nibble ID mode.

If you are using a parallel port to communicate with the printer, you

need:

• an IEEE 1284 interface adapter installed in the printer.

• a parallel cable to run between the printer and the PC.

To connect the printer to your PC using an IEEE 1284 cable:

• Connect the IEEE 1284 cable connector to the interface adapter

port on the back of the printer and connect the other end of the

cable into a parallel port on the PC.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 149 150

Sin comentarios

Intermec PM43c Manual de usuario Pagina 51